Development boards are essential in embedded electronics and here we present the small ATtiny85 development board. The ATtiny85 is a compact Development Board from the Arduino community. It is based on the 8-pin ATTiny85 ATMEL Microcontroller and has 6 Digital pins, out of which 4 pins are ADC compatible. It also has 3 PWM outputs and supports SPI, I2C and USART communication. The Flash memory size is about 8K. It operates on 5V and also has an on-board voltage regulator which can take input voltage up to 12V. The board comes with a preloaded bootloader with blink sketch and can be easily programmed using the Arduino IDE. It features a micro usb port that can be used for data transfer and power related inputs. The USB line is fully protected using the TVS diodes. AT tiny Micro USB 85 Development Board AtTiny Development Board Features and Specifications: Specification: High Performance, Low Power AVR® 8-Bit Microcontroller Non-volatile Program and Data Memories 8K Bytes of In-System Programmable Program Memory Flash Endurance: 10,000 Write/Erase Cycles 512 Bytes In-System Programmable EEPROM 512 Bytes Internal SRAM Peripheral Features Two High-Frequency PWM Outputs with Separate Output Compare Registers USI – Universal Serial Interface (12C, SPI, 1-wire) with Start Condition Detector 10-bit ADC 4 Single Ended Channels Two Differential ADC Channel Pairs with Programmable Gain (1x, 20x) Speed Grade 0 – 10 MHz @ 2.7 – 5.5V, 0 – 20 MHz @ 4.5 – 5.5V Industrial Temperature Range Low Power Consumption Active Mode:1 MHz, 1.8V: 300 µA AtTiny Development Board Applications: Programming System Motor Control Logic Devices Data processing Data logging
