This is an official Raspberry Pi Zero case with a camera Strip and rubber pad. This Original Pi zero case has a clear engraved Raspberry Pi logo on high-quality ABS case. The Raspberry Pi Zero Case has been designed to fit both the Pi Zero and the Pi Zero W and Pi Zero 2W The Raspberry Pi Zero Case consists of two parts. It has a standard base featuring a cut-out to allow access to the GPIO, and a choice of three lids: a plain lid, a GPIO lid (allowing access to the GPIO from above), and a camera lid (which, when used with the short camera cable supplied, allows the Raspberry Pi Camera or Camera Noir to be fitted neatly inside it) It also comes with an exclusive short ribbon cable that will connect your camera module to your Raspberry Pi Zero and Pi Zero W and 2W. Also included with the four sticky rubber feet that fit into the indents on the underside of the case. The underside of the pi zero case features a cut-out for the GPIO pins which means you always have access to expand your Raspberry Pi Zero and add sensors, LEDs, switches and all manner of other things. This case is compatible with all models of Raspberry Pi Zero including the new Raspberry Pi Zero W and Raspberry Pi Zero 2W NOTE: This is only Pi Zero case, Pi Zero board not included. Features: Good Quality ABS Material. GPIO access (allowing access to the pins for HATs, pHATs and/or jumper cables). Camera Mount & Lens hole. Accurate fittings.
