ST-Link V2 Mini STM8 STM32 Simulator Download Programmer

This is a Mini ST-LINK/V2 on a small single board. It is an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32 microcontrollers from ST Microelectronics. It is a toned down version of ST link V2 In line programmer/ debugger for STM8 and STM32 microcontrollers. It has USB 2.0 to connect to your PC and SWIM/SSD interface for communication with microcontrollers. It supports both 3.3V and 5V to easily connect the MCU. The U disk aluminum housing protects the simulator from static electricity and wear and tear due to rough use and provide protection against shocks, operational errors and malfunction. Specifications Onboard 500mA self-recovery fuse to avoid short circuit Dual voltage output (3.3V/5V), easy for debugging and programming Standard USB interface for direct connection to PC Debugging: run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc. Programming: supports FLASH ROM, EEPROM, AFR, etc. Automatically Upgradable firmware to support more devices Supported software: ST-LINK Utility v2.0, STVD Version 4.2.1, STVP Version 3.2.3, IAR EWARM, IAR EWSTM8 Revision v1.30, KEIL RVMDK Revision v4.21, ATOLLIC Supported devices: STM8 devices with SWIM interface and STM32 devices with SWD interface Product Description As is has a USB 2.0 port onboard so you can just plug it in the PC and download the programming or debugging software you are planning to use and start working on it. Make sure you connect the correct pins from the output port to the Microcontroller you are using. Features : PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable! Interface definition directly marked on the shell, clear, convenient, and practical! 5V and 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V Shell characters using laser engraving, never fade off! Permanent clarity! 500MA internal resettable fuse, complete protection of your expensive computer motherboard! Red and blue color LED indicator, allowing you to always observe ST-LINK V2 working condition! With 4 DuPont lines, so you can easily respond to different target board line orders! Use anti-static bag packaging. SWIM-SPECIFIC FEATURES: SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector 1.65 V to 5.5 V application voltage supported on SWIM interface SWIM low-speed and high-speed modes supported SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed SWIM cable for connection to the application Direct firmware update feature supported (DFU) Status LED which blinks during communication with the PC Operating temperature 0 to 50°C Software Download Link: https://www.st.com/en/development-tools/st-link-v2.html   Package Contents 1× ST-Link V2 Mini STM8 STM32 Simulator Download Programmer 4× Cover DuPont Cable